Draeger Safety

The Accuro® gas detector pump is a manually operated bellows pump that draws a calibrated 100 milliliter sample through the short-term Dräger-Tubes. Features a one-hand operation, very low maintenance, end-of-stroke Indicator and built-in automatic stroke counter. The Accuro® 2000 can be set to take up to 199 pump strokes for making measurements of very low gas concentrations. Up to 500 pump stokes can be taken on a charged battery. Quantimeter 1000 is a battery powered gas detector pump that...
|Single Gas Detection Tubes
Accurate gas measurements are made easier with the Draeger CMS. This new generation spot check detection device is literally as easy as 1,2,3 to operate. Simply insert one of the over 50 chemical specific CMS chips and follow the instructions on the display as to when to move the slide switch. TWA levels are typically analyzed in 1 to 2 minutes. Upon completion of this process, the concentration is indicated on the LCD display. Every chip uses the exact same procedure so training is...
Put the simplicity of the CMS to work for you in your emergency response procedures. This kit contains the CMS Analyzer, the appropriate accessories and a selection of 10 different Chips for response to HazMat or other situations. The CMS is easy to use, with all Chips using the exact same procedure. The Chips never need calibration and the Analyzer does not require battery charging. All of the needed accessories are placed in one rugged carrying case, ready to go at a moments notice. Use our...
Direct-reading Dräger diffusion tubes were developed especially for personal exposure monitoring. These systems do not require the use of a gas detector pump because the contaminant molecules pass into the tube by diffusion processes and in this manner are brought into contact with the reagent systems.
For short-term measurements more than 160 Dräger-Tubes are available to measure the so-called spot concentrations of specific gases. A wide range of different gases and vapours can be detected and measured, e.g.: Determining and measuring concentration peaks, Measuring personal exposure in the inhalation area, Detecting leaks in pipelines, gas installations etc., and Air analysis in sewers, shafts and confined spaces.
Draeger offers SCBA cylinders in different sizes and construction to meet the demands of different applications. Cylinders are offered in 2216(low pressure) and 4500 psi(high pressure) operating pressures. Durations of 30,45 and 60 minutes ( at 40L/min breathing rate) are available. choose from aluminum, fiberglass hoop wrapped or lightweight carbon fiber full-wrap construction.
All gas detection sensors require periodic calibration or bump testing. Graeger offers a full rangev of cailbration gas mixtures in various concentrations and related supplies.
Assessories for various monitors
The E-Cal System makes calibrating your Draeger gas detection instruments easy while saving time and mony. The E-Cal system automatically calibrates up to 10 gas monitor and documents the entire process making it ideal for ISO-9001 compliance. The E-Cal station also bump tests, downloads stored information, charges the instrument, and changes instrument configurations with the included CC-Vision software. This computer control ensures that the calibration is done properly every time...

Pages